Description:
TSE018A02-A1 is 1.8 inch E-ink display with 224x168 resolution, it is 24 pins 3 wire SPI interface.. It has no backlight, so it is very low power consumption. Its feature is high contrast and high reflectance, ultra wide viewing angle, and pure reflective mode. Operating temperature is 0 ~ +40°C, storage temperature is 0 ~ +50°C.
Drawing:
Specifications:
General Specification | ||
Part No. | TSE018A02-A1 | |
Outline Dimension(mm) |
45x32x0.9 |
|
Active Area(mm) | 27.05x36.06 | |
Resolution(dots) | 224x168 | |
Operating temperature(°C) | 0 ~ +40°C | |
Storage temperature(°C) | 0 ~ +50°C | |
Pin Number | 24 | |
Touch panel | without | |
Driver IC | SSD1680 | |
Pixel arrangement | RGB-stripe | |
Display mode | High Contrast 1.8 inch E-ink Display | |
Surface treatment | Antiglare | |
View direction | All o'clock | |
Weight(g) | TBD | |
Power Consumption(w) | Panel | TBD(Typ.) |
B/L system | TBD(Typ.) | |
Interface | SPI |
|
Module lifetime(Hours) | 30,000 hours |
Pins Description | ||
Pin No. | Symbol | Description |
1 | NC | No connection and do not connect with other NC pins |
2 | GDR | N-Channel MOSFET Gate Drive Control |
3 | RESE | Current Sense Input for the Control Loop |
4 | NC | No onnection and do not connect with other NC pins |
5 | VSH2 | Positive Source driving voltage |
6 | TSCL | I²C Interface to digital temperature sensor Clock pin |
7 | TSDA | I²C Interface to digital temperature sensor Data pin. |
8 | BSI | Bus selection pin |
9 | BUSY | Busy state output pin |
10 | RES# | Reset Signal Input |
11 | D/C# | Data /Command control pin |
12 | CS# | The chip select input connecting to the MCU. |
13 | SCL | Serial clock pin for interface. |
14 | SCL | Serial data pin for interface. |
15 | SCL | Power input pin for the Interface. |
16 | SCL | Power Supply pin for the chip |
17 | SCL | Ground (Digital) |
18 | SCL | Core logic power pin |
19 | SCL | Power Supply for OTP Programming |
20 | SCL | Positive Source driving voltage |
21 | SCL | Power Supply pin for Positive Gate driving voltage and VSH |
22 | SCL | Negative Source driving voltage |
23 | SCL | Power Supply pin for Negative Gate driving voltage, VCOM and VSL |
24 | SCL | VCOM driving voltag |
Other Features of E-ink Display:
1) Bi-stable display
2) Commercial temperature range
3) Landscape, portrait modes
4) Hard-coat antiglare display surface
5) Ultra Low current deep sleep mode
6) On chip display RAM
7) Low voltage detect for supply voltage
8) High voltage ready detect for driving voltage
9) Internal temperature sensor
10) 10-byte OTP space for module identification
11) Waveform stored in On-chip OTP
12) Serial peripheral interface availabl
13) On-chip oscillator
14) On-chip booster and regulator control for generating VCOM, Gate and Source driving voltage
15) I2C signal master interface to read external temperature sensor/ built-in temperature sensor